Lezbein
05-22-2007, 10:49 PM
Hey all, how to mix plants types together, like skunk and jamican gold? Or 2 different hazes together.
I seen a way, but I learned it from a garden show, Martha Steward I think, the plant they used was not weed of course, so I was wondering if this techinque is possible with our favorite plant instead.
Well, basically as a seedling about 4 - 5" tall maybe abit taller; you take 2 different plants and split it down the middle, not too far down, you wanna leave some room at the bottom. Cut off one side of the plant and leave the other side intact. Now you just switch the pieces you cut off and carefully put it on the oppsite plant -almost like doing patch work or fitting a puzzle piece in it's place- and use string to keep it in place. You can wind the string up the plant like a corkscrew for a good hold and tie it at the end and start of the cut, or just tie it off every few inches. In time they will grow into each other and hopefully produce a hybrid.
tip: Make sure if you cut something like 3 1/2" down the plant you cut the same length on the other plant. If you don't the two pieces won't match up evenly. They may overlap or be too short.
P.S. After I try this, would any current existing leaves and nodes still produce one weed type? If I cut off all nodes and let it regrow from the start, would it regrow the same or hybrid?
I seen a way, but I learned it from a garden show, Martha Steward I think, the plant they used was not weed of course, so I was wondering if this techinque is possible with our favorite plant instead.
Well, basically as a seedling about 4 - 5" tall maybe abit taller; you take 2 different plants and split it down the middle, not too far down, you wanna leave some room at the bottom. Cut off one side of the plant and leave the other side intact. Now you just switch the pieces you cut off and carefully put it on the oppsite plant -almost like doing patch work or fitting a puzzle piece in it's place- and use string to keep it in place. You can wind the string up the plant like a corkscrew for a good hold and tie it at the end and start of the cut, or just tie it off every few inches. In time they will grow into each other and hopefully produce a hybrid.
tip: Make sure if you cut something like 3 1/2" down the plant you cut the same length on the other plant. If you don't the two pieces won't match up evenly. They may overlap or be too short.
P.S. After I try this, would any current existing leaves and nodes still produce one weed type? If I cut off all nodes and let it regrow from the start, would it regrow the same or hybrid?