just made some cuttings

[stoner 420]

hey everyone i just made two cuttings off a very very good strain and was just woundering how long does it take for to develop a root system strong enough to begin flowering.... this is how i took the cutting... first. i found an elongated stem just perfect for cloning second . i cut it just below the third node down at a 45 degree third . gently scraped the outer layer off the bottom of the cutting and dipped it in so cloning gel i got from my hydro shop and then put them in the container.... pls tell me what you think ......

[THE BROTHER'S GRUNT]

Sounds like ya did everything right. It will take about 2 weeks for a nice root system maybe sooner maybe longer. ;)

[stoner 420]

thanks TBG i appreciate the info i just hope that they root cause i made my own hydro setup and i am worried the medium i and useing will not work for this but mayb i will pull a rabit out of a hat.. lol.. thanks again.....

[PurpleSkunk]

best of luck to you sounds like u got it all down i got a few clones going also,jiffy pellets and rootone powder,in a 5gallon plastic water jug for good hummidity,i hope all goes well with your hydro medium and you get some roots,just be patient even if u go 3weeks u can wait to see new growth or u can pull up to take a peak,see whats going on just add more gel or powder when putting back in and be careful, as long as they are not dying they will most likely root imo.PS

[Growdude]

I use a 1x1 rockwool cube for clones, will go right into any kind of hydro system.