YYZ Skinhead
RIP Neil Peart 9/12/1952 -- 1/7/2020
When I travel out of state, this is the sort of bong I use. Ordinarily I use a smaller bottle than the gallon jug in the pix, but any thin plastic bottle will do. The bowl and slider apparatus can be bought at any head shop.
Ingredients:
1 plastic bottle, e.g. a 16 oz pop bottle
1 bowl and slider (glass preferably, but metal works as well)
1 rubber grommet (the black ring around the stem/slider that seals the hole)
1 X-Acto knife, razor blade and/or exceptionally sharp scissors
1 pen to mark the hole in the plastic
1 lighter to heat the blade
Hold the bowl and slider to the bottle and draw a circle with the pen around the bottom of the slider to mark where you want the hole to go. Draw a thin line at the bottom of the drawn circle to make an ellipse shape that is only slightly bigger than the slider diameter, so that the slider will fit at an angle. Heat the sharp blade to make it easier to cut. Cut the drawn ellipse shape out of the bottle. Insert the grommet into the hole. Insert the slider/bowl. Add water. Get some. :bongin::bong1::bong2::vap-Bong_smoker:
Ingredients:
1 plastic bottle, e.g. a 16 oz pop bottle
1 bowl and slider (glass preferably, but metal works as well)
1 rubber grommet (the black ring around the stem/slider that seals the hole)
1 X-Acto knife, razor blade and/or exceptionally sharp scissors
1 pen to mark the hole in the plastic
1 lighter to heat the blade
Hold the bowl and slider to the bottle and draw a circle with the pen around the bottom of the slider to mark where you want the hole to go. Draw a thin line at the bottom of the drawn circle to make an ellipse shape that is only slightly bigger than the slider diameter, so that the slider will fit at an angle. Heat the sharp blade to make it easier to cut. Cut the drawn ellipse shape out of the bottle. Insert the grommet into the hole. Insert the slider/bowl. Add water. Get some. :bongin::bong1::bong2::vap-Bong_smoker: