Recent content by Balzo905

DDos#3

Thx for stopping by, High :) My sprays are legit always checking the cuts every couple days to make sure they're all nice and drippy. Thinking its the temp, not much i can do for the ones that haven't rooted yet besides leave them in the cloner. That being said, don;t think i can leave the...

What's up MP No pics today as I'm kinda busy but here's my quandary.. 13 cuttings; you can see the previous posts for pics, and after 1+1/2 weeks all cuttings on the inside "ring" (7) have rooted, and grown extreme mass. On Friday I switched the inside and outside rings and now the other...

Negative, and my pump is never on for more than 25min at a time (will post my timer settings after I finish the batch). Maybe that's enough to generate some heat but literally everytime I check the temp it's always the same. :vap-Bong_smoker:

So in the pic, ive got two of those heaters; when i was at the store i figured it was better to spend double and have more than enough heat/an extra than buy one and need to go out again. After putting them both in and letting it run for a few hours, it was well over 80 so removed the second and...

THGeeee How much water does the EZ hold? Bought a $20 dollar Betta bowl heater, doesn't have a temp dial or anything and it keeps my 2gallons at a constant 74. Phones about to die will explain my pump setup in a minute :)

:vap-leafy_wave: Whats up MP quick update here, as about half of the cuttings have shown roots, and every cutting has grey/white bulbous growths near the bottom that i can only assume to be "preroots" here's a few pics, enjoy and leave me a nice one :) C+Gv

Beautiful

Whats up MP quick update here as i just finished my cloner project and my girls got a nice trim up last night. The 2nd and 3rd pics are post-clone. As per THGs suggestion ive been expanding my nutrients stock a bit, picked up this new RAW minerals Nitrogen a couple weeks ago and have had plants...

Went to the store for Netpots, Left the store with Netpots, Cloner solution (Grotek KickStart), RAW Nitrogen, New pH meter, Measuring droppers aand a new spray bottle. RO had a pH of 5.8 and a ppm of 0.09; ran with it. Added the KickStart formula at half the recommended dosage, water has a...

So the RO water characteristically has a lower pH apparently, something between 6-5, but I've been reading that that is only because of the low number of hydrogen molecules that are present in the water. Says it would only take miniscule amounts of pH up (baking soda) to throw it off completely...

Whats up MP thanks for the help JOECAMEL and SKYHIGH Cloner#2 Started with a new 5 Gal Bucket, and covered the outside of the lid in GorillaTape to keep the light out then i traced out my net pot map on the underside, and made a pilot hole for each location using the 11/64" drill bit...

Could be a possibility, going with the RO for the second go.

I hear ya; It's almost the weekend, and I'd rather not take 14 cuttings and have them all die. So, I'm just going to use a new 5gal and make a new one. My stuffs 100% food grade but maybe there was a bit of residue from a dishwater or the like.. Won't take too long I'll try and take a couple...

Been running (without clones) for the last 3/4 hours, took the lid off and found a bit of "foam" or bubbles collecting on the surface of the water... This is just plain tap well water for now is this normal or is there maybe some soap or something in my pump?