Recent content by th3dr0

Don't worry, I haven't forgot about you all ;) My card reader has failed, and pictures can't be uploaded. It should be fixed within the week, and you can get a peak at the beauty, it is doing excellent, better then i ever expected.

Lst is definately being considered, due to the size. I appreciate everyone's support.

Small amounts of heat burn on 1 plant after forgetting to turn on the Ac. Nothing to serious. Pistils are beginning to show, males will be tossed, and more room will be created for the females to flower. Some pics below.

The plants where put on 12/12 as of yesterday. As you can see the roots are excessive from the extreme amount of oxygen. The clear sides of the container will be covered today so light cannot reach the roots, even though very little can currently.

It cost me $30 :) As you said i have seen them ranging from 5-800. Very efficient.

Thank you! Finally some support :).....Come on people its not everyday you see someone grow an exotic strain out of a PC case!! ;)

Lookin good.

The setup has been re-arranged now the the plants are getting bigger. The lights have been more efficiently setup, and the airflow is now going from the top rear of the case, and out the bottom front. This was done in order to better cool the lights.

10 Days later and the hydroponic system installed. Plants are looking pretty good. Had some heat issues today after forgetting to plug in the exhuast fan : 0 I added some flare to the first few pics ; )

Doesn't really look like white russian.

24 hours later and 100% germination. (pic 1) The seeds have been transplanted to the media in which they will continue sprouting. (pic 2) A duct from my AC vent has been added to the front of the case for temp/humidity control. It is set at 70 Degrees farenheight to combat the high temps of...

I don't think the issue is to much light, rather to much heat. Try cooling down the light with a fan, or raising it a bit.

You could probably find a setup with a digital switchable ballast for around the same price.

Yes the fan is still intact and running, the wire is running out of the bottom of the supply, you can't really see it in the pic.

That was done too raise the temp of the power supply; the fan you see there is the fan that was in the power supply. The sole purpose of the power supply is to warm the seeds for germination, it would not get warm enough with its internal fan running.