Recent content by Chriswhit123

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. Chriswhit123

    Can I save a Hermie still in vegetation?

    I missed a few hermie pollin sacs on my first grow and had so many seeds that you had to brake up 6inch buds to get a couple joints. the rest was all seeds
  2. Chriswhit123

    CLONES NEED HELP

    sitting in the runoff may be an issue. the ph of coco is different than soil which may slow rooting in the beginning. did you rinse the old grow medium off and put in coco? i never mess with the soil around new rooted clones because i worry about shocking them or killing them.
  3. Chriswhit123

    CLONES NEED HELP

    ive also found to many leaves makes barely rooted clones take a lot longer to perk up. if i get one that wont perk up i cut off a leaf or 2. before you go doing that id try top watering instead. dont flood the soil just damp is fine
  4. Chriswhit123

    CLONES NEED HELP

    coco is harder to grow in. many of my aeroponic clones take 5-7 days to get perky. I give a light dose of kelp on day 4. voodoo juice by advanced nutrients helps rooting so if I have it I'll do a 1/4 dose with the kelp. top water because thats where your roots are. its easy to over water if your...
  5. Chriswhit123

    My first grow.

    unknown or bag seeds have there disadvantages like could be a male which would be a bummer could be a female to. hope its a female and turns out to be good for you. my first grow I did the same but I did 10 before the first state to legalize medical mj. I was 14. got lucky and got just 1 male...
  6. Chriswhit123

    Seeded Weed, I remember.........................Anyone else?

    Ive made so many clones so many different ways. built a aeroponic cloner. you can do it without a cloner to. what you need help with
  7. Chriswhit123

    Humboldt Seed Organization

    hso got busted and shut down
  8. Chriswhit123

    this year so far

    good point about the size though
  9. Chriswhit123

    this year so far

    the burner on natural gas is smaller for less flow and the manifold reflects that. the regulator for natural gas line is smaller my tutorial will explain all this as sizes are different due to the pirated components being larger for propane. the idea is you go with your feed size to determine...
  10. Chriswhit123

    this year so far

    11psi is propane and the pressure of natural gas is 4 and 1/2 psi page 8 of the pdf
  11. Chriswhit123

    this year so far

    The regulator may not be needed if your supply line is already regulated.
  12. Chriswhit123

    this year so far

    Yes can use natural gas it does require a different burner for natural gas. They look the same but setup for different pressure. It also requires a natural gas regulator. Most places that sell replacement burners would have both. I’ll be doing my tutorial this week after my auto shop closes due...
  13. Chriswhit123

    RO system questions

    I know I’ll end up needing another ro system for a grow like that but to me efficiently utilizing the system means less power. If I’m dumping 150 gallons a day in waste water at max effiency lower temps mean 300 gallons or more a day in waste. 300x30 would be 9000 gallons of waste a month as...
  14. Chriswhit123

    RO system questions

    At max efficiency my system is 50 gallon per day. I have 25-30 mother plants alone. They will be dwindled down 7 strains 4 of each. A few will end up male. I’m picking the best mother of each. This is a joint grow with me and 3 other medical card holders
Back
Top