nitrogen burn

Discussion in 'General Indoor Growing' started by saticus, Jun 1, 2009.

  1. Jun 1, 2009 #1

    saticus

    saticus

    saticus

    Well-Known Member

    Joined:
    Apr 18, 2009
    Messages:
    96
    Likes Received:
    65
    i just burned my hydro plants.:eek: too much nitrogen.:rolleyes: but i found a way to save them.:D it requires going back to the vegetative state so i will have to wait for harvest:hubba:

    for those who run into this problem, here is what i found.;)

    DO NOT use miracle grow!!!:holysheep:

    change back to 24 hr light
    change water
    flush plant roots with plain water
    add proper nutrients to feed
    wait for new growth to appear at base of stems
    once new growth appears remove dying leaf
    new growth MUST appear before removing leaf
    once you are sure all new growth has appeared, remove all remaining dying or dead leaves

    good luck
     
  2. Jun 1, 2009 #2

    Caretaker

    Caretaker

    Caretaker

    Rx THC

    Joined:
    May 28, 2009
    Messages:
    211
    Likes Received:
    121
    You should be more specific when saying not to use MG. Alot of people do know how to control the fert and use it to where it works for them. You should explain why it didnt work for you because some people can only get or afford that stuff. So they must find a way to make it work and if you warn them about what exactly what was up with the specific fert you used it would be good info. MG has more than one fert and we dont know which one you used or how much you used to cause the burn. Maybe you went on to strong.
     
    saticus likes this.
  3. Jun 1, 2009 #3

    CoolAsAFan

    CoolAsAFan

    CoolAsAFan

    Well-Known Member

    Joined:
    Apr 1, 2009
    Messages:
    101
    Likes Received:
    65
    just curious, why was revegging required?
     
  4. Jun 1, 2009 #4

    HippyInEngland

    HippyInEngland

    HippyInEngland

    Smoke Free Zone.

    Joined:
    May 24, 2007
    Messages:
    8,630
    Likes Received:
    14,307
    You used miracle grow liquid in a hydro set up?

    :peace:
     
  5. Jun 2, 2009 #5

    saticus

    saticus

    saticus

    Well-Known Member

    Joined:
    Apr 18, 2009
    Messages:
    96
    Likes Received:
    65
    beginners stupid mistake. i used a blooming liquid and it killed the leaves. the leaves feed the bud so i basically killed them or at leased shocked the %&* out of them. i will get pics, if i can. sorry if i seem odd but i'm new at this forum stuff.:)
     

Share This Page