Recent content by Melnick

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. M

    250 hps

    I was thinking of using a 250 hps for flowering. I was looking at 4-6 plants. I have unlimited space, so that would not be an issues. It can be a small grow room or a large grow room. With the 250 hpc i was looking at a small area. Any suggestions . Thanks.
  2. M

    Clones

    After four attempts or 24 clones I decided to dig out my old, very old office lights and start over. I had almost 100% using these old lights, so I know it will work. I guess the simple way is best sometimes. Thanks for all the advise, very helpful.
  3. M

    Clones

    Thanks BBFan. I was wondering about one thing. I cut my clones last night and this morning that are almost dead. I did mist them a lot, a lot and a lot. Could over watering could cause this. If so then I found my problem.
  4. M

    Clones

    Something else somebody pointed out was that the plants were too moist. I use to spray them twice a day, now I spray them every hour. So maybe they are getting to much water. I lost my clones over night. So I will cut more today and spray them twice a day and see what happen.
  5. M

    Clones

    The lights are led and I am cloning in peat moss pellets. I prepared 5 clones about 5 hours ago and now the leaves are turned up, like they are drying up. I am leaning towards the problem being the lights. The florescent lights I used before, I could put the dome close to the lights. Because...
  6. M

    Clones

    I have cloned before with good results. I built a better cloning area, but the lights are different than what I have used before. I have attempted to clone 4 times with bad results. My question is what is the best distance between the dome and the lights. I am using a small plastic cloning...
  7. M

    Clone question

    Thanks
  8. M

    Clone question

    While the dome is on, whats a good distance from the light.
  9. M

    Clone question

    How long to you keep the dome on while cloning. I was told just a few day, but I keep them on the entire time. I am trying to improve my cloning. I am also thinking of adding a heating pad to keep the roots and soil warm. Last question,what is the distance from the clones and the light...
  10. M

    phosphorus deficiency

    Information on my girls. outdoor grow one month into veg Happy Frog soil Fox Farm Nutes PH: 6.6
  11. M

    phosphorus deficiency

    What is the best way to treat phosphorus deficiency. My littler girl is 1 month old. Thanks.
  12. M

    Bending

    It was a silly question, but I had to ask. Thanks for the help.
  13. M

    Bending

    Just wanted to know if you tied down a plant for about 3 month, would that cause additional stress, which might lead to other problems.
  14. M

    Bending

    I have always bent my girls around a wire, so the plant would grow in a circle, about 6 inches in diameter. I did this to keep my girls small. It was an experiment that went wrong. They are tied from about three weeks till I cut them down. I have had major problems and little results. I was...
  15. M

    nute question

    I think I will increase the strength to see what happens and just maybe my girls will do better. Thanks.
Back
Top