deadkndys
Well-Known Member
- Joined
- Aug 14, 2013
- Messages
- 185
- Reaction score
- 5
So I made a CS generator yesterday and have been letting the silver sit for almost 24 hrs. This morning when I checked on it, it was at 11 ppm after sitting for 14 hours and just right now i looked and it was at 13 ppm. I also switched the silver on the negative to the positive and vice versa this morning so maybe thats why it rose a little bit.
So is this as far as it will rise or should I just let it go for a few more hours? ( I am aiming for 50-60 ppm)
I still have some silver wire left over (.9999) as well so I could just use fresh ones if it could raise the PPM.
I am also using a 9v.
So is this as far as it will rise or should I just let it go for a few more hours? ( I am aiming for 50-60 ppm)
I still have some silver wire left over (.9999) as well so I could just use fresh ones if it could raise the PPM.
I am also using a 9v.
