stepheneking
Well-Known Member
Hello fellow MP memebers! I have been digging in to find the best way to setup a budget tetrafluroehane (HFC-134A); yes freon 134a, extraction setup. Before I get to far into it I have been doing a lot of digging and research on the caracteristics of 134a used instead of propane, butane or eth0nal.
I am also looking to do this with low temps and low pressure. I am also looking for a efficient setup using PVC. I have been looking at the butane extraction reaction to Polyvinyl chloride weaking and leaking into the oils. I have also looked for the reactive properties where freon 134a is used in a PVC application. According to my findings, there is little reactive properties where the mineral oils and eth oils have been removed from 134a.
Is there anyone out there fimilar with using PVC not with butane or propane but with low pressure freon 134a?
It would be a closed loop system..mainly if there is little reactive properties from the freon and the pvc. In the case for low heat and pressure. It could make for a good low budget PVC build for the do it yourselfer!
Thoughts friends!?
I am also looking to do this with low temps and low pressure. I am also looking for a efficient setup using PVC. I have been looking at the butane extraction reaction to Polyvinyl chloride weaking and leaking into the oils. I have also looked for the reactive properties where freon 134a is used in a PVC application. According to my findings, there is little reactive properties where the mineral oils and eth oils have been removed from 134a.
Is there anyone out there fimilar with using PVC not with butane or propane but with low pressure freon 134a?
It would be a closed loop system..mainly if there is little reactive properties from the freon and the pvc. In the case for low heat and pressure. It could make for a good low budget PVC build for the do it yourselfer!
Thoughts friends!?